The only real bug I found was the air crash sometimes fails to remove the model. My brother had a nice couple of 1v1s when I found this.

I had a whole thread made awhile back trying to figure out a way to do this, but was never able to create it so that the missiles would work exactly like in SupCom, also a few believed that it would most likely be game-breaking in SC2's engine when there were masses of units in play.ДЄlso due to this fact I will over time balance quite a few things since they don't behave exactly like in SupCom, Artillery for instance is one of those.

For instance, you'll still have the SC2 effect of the t2 tanks shooting through buildings to hit targets on the other side.' Since this map does not have that, the behavior of the battles does differ a little. (I'm sure you know this) So, thus, each shot is calculated and has it's own trajectory. 'Also, all munitions in Sup Com are individually simulated. The T3 artillery however may still remain the same as it is at the moment the most expensive unit in the game.

A button that scatters units in a group? Not sure how that would be possible =/ as for artillery, I may increase the time period between launch and impact because yes I know it is at this point extremely effective against ground units.

Units clump so tight that a few good barrages leaves you smashed.' Artillery are just absolutely dominate in this map because SC2 pathing is so good. 'For game play reasons, a scatter button would be nice.

I'll see what I can do, but I didn't come up with the Air Crash system.

After large air battles, there will be a few of the crashed air craft model on the ground that are un-selectable and black but never go away.' Youtube Video of Gameplay brother had a nice couple of 1v1s when I found this.

There is only one race implemented as there are not nearly enough units to complete all 3 races.Д¬redits to Gas Powered Games for creating the original Supreme Commander game and inspiring this project.

Was only able to half-implement the resource income/cost system.

Adjacency system for economic structures.

SEARCH FOR: Supreme Commander ДЇeatures I was not able to implement from the original game: This map is based off both Supreme Commander & it's expansion Supreme Commander: Forged Alliance.

The T1 Land Factories model seems to disappear for a short time after being constructed (Cause Unknown at this time.).

AA attack of the EX Assault Bolt: Megalith has been upgrade.

AA attack of the EX Aircraft Carrier: CZAR has been upgraded.

Victory is rewarded to the player who is able to conquer all other players on the map. To produce Energy you must construct Power Generators, all generators are volatile as well so be careful when constructing these as you may want to keep them apart from your high-value structures while still keeping them protected from an opponent who seeks to damage your economy. It is also worth noting that Mass Fabricators are volatile, in that they explode when destroyed, damaging all nearby units. A secondary way to acquire mass is through the construction of Mass Fabricators, these method however is inefficient as there is a rather large amount of energy used to produce mass through these structures. To acquire mass you must construct Mass Extractors on Mass Deposits, several of which are located nearby, others you must expand your base to control. Supreme Commander uses only two resources, Mass and Energy, to produce units.

These are usually massive units which take a lot of time and energy to produce, but provide a significant tactical advantage. The fourth tier is a limited range of 'experimental' technology. The third tier level has very powerful assault units designed to overcome the fortifications of the most entrenched player. The second tier expands the player's abilities greatly, especially in terms of stationary weapons and shielding, and introduces upgraded versions of tier one units.

The first tier is available at the start of the game and consists of small, relatively weak units and structures. Certain lower-tier structures can be upgraded into higher ones without having to rebuild them. I) TiersДЄll units and structures belong to one of four technology tiers, or 'Tech' levels, each tier being stronger and/or more efficient than the previous. Supreme Commander is focused on using an Armored Command Unit (or ACU) to build a base, then upgrading units to reach higher technology tiers, and conquering opponents. I present to you all Supreme Commander, an adaption to the massive RTS game Supreme Commander & Supreme Commander: Forged Alliance.

Supreme commander 2 maps